Location:HOME > NEWS > Technical requirements for stainless steel elbow

Technical requirements for stainless steel elbow

2022-03-07 10:53:39   COMMENT:0 HITS:
The technical requirements of stainless steel elbow control the radius of curvature. For example, if the radius length is 1.5D, the radius of curvature must be within the required tolerance.
Since most of these pipe fittings are used for welding, in order to improve the welding quality, the ends are turned into grooves, with a certain angle and a certain edge. This requirement is also strict. There are provisions on the thickness of the edge, the angle and the deviation range, and there are many more geometric dimensions than the pipe fittings.
The surface quality and mechanical properties of elbow are basically the same as those of pipe. For the convenience of welding, the material of steel shall be the same as that of the connected pipe.
1. Since most of the pipe fittings are used for welding, in order to improve the welding quality, the ends are turned into grooves, with a certain angle and a certain edge. This requirement is also strict. There are regulations on the thickness of the edge, the angle and the deviation range. The surface quality and mechanical properties are basically the same as those of pipes. For the convenience of welding, the steel grade of pipe fittings and connected pipes is the same.
2. That is, all pipe fittings shall be subject to surface treatment, and the iron oxide scale on the internal and external surfaces shall be sprayed off by shot peening, and then coated with anti-corrosion paint. This is to facilitate transportation and prevent corrosion and oxidation.

previous_pagefirst_page
next_pageWhat is the usefulness of flange?

<ALL>